Sealing failure on a packaging machine comes down to five causes — jaw temperature drifting from its setpoint, insufficient or uneven pressure at the jaw face, dwell time that shrinks as line speed rises, contamination in the seal area, and the film itself. Four of the five can be checked by hand and a stopwatch in under half an hour. None of them is fixed by turning the temperature up, which is what most plants try first.
- ✓ Define the failure before you touch a setting. A leak, a weak seal and a cosmetic defect have different causes and different owners.
- ✓ Temperature, pressure and dwell have to be right at the same moment.
- ✓ One-sided channels mean uneven jaw temperature or non-parallel jaws.
- ✓ A film batch number written against failure rate finds film-related causes within a month.
| Cause | The signature you’ll see | First thing to check |
|---|---|---|
| Jaw temperature drift | Strong seal on one side, channel/peel on the other; failures cluster after stops | Jaw surface at left, centre and right vs controller |
| Pressure / geometry | Sealed ends, leaking centre; wrinkles along one edge | Contact impression through carbon paper |
| Dwell too short | Passes at demo speed, fails at production speed | Actual dwell measured at rated speed |
| Contamination | Channels in same corner; product or condensation in seal | Fill station and air knife, not the jaw |
| Film | Failures cluster mid-roll or after supplier change | Film batch number against failure count |
A sealing failure is the most expensive kind of small problem. Nobody gets hurt, nothing catches fire, the line keeps running — it just quietly ships product that leaks, blooms or gets rejected at the customer’s warehouse six weeks later.
Before you touch a setting, define the failure. Three different problems get called “sealing failure”:
- Leak — the pack passes visually but fails a pressure or vacuum test.
- Weak seal — holds at first, peels open in transit or on the shelf.
- Cosmetic failure — wrinkles, channels, product in the seal, burnt edges.
1. Jaw temperature is drifting, not wrong
Thermocouples drift. Controllers overshoot on start-up. Jaws heat unevenly end to end because the cartridge heaters are spaced for average, not for the edge where heat escapes fastest.
2. Pressure, or the lack of it where it matters
Gauges read air pressure at the regulator, not force at the jaw face. Between those two points you have a cylinder, a linkage, and two jaw faces that wear.
3. Dwell time versus line speed
Dwell time is the variable that goes wrong when production wants to run faster. Raise the cycle rate and dwell shrinks. Seals start failing at high speed while passing at demo speed.
4. Contamination in the seal area
Powder, oil, sauce, crumbs, and condensation. All of them prevent the two sealant surfaces from meeting. This is often a fill station issue ten metres upstream.
5. The film itself
Film is the variable everybody assumes is constant and it never is. Gauge variation across the roll, storage humidity, and age all affect the sealing range.
The 20-minute diagnostic, in order
- Look at ten failed packs together. Identify the mode.
- Check jaw temperature at three points against the controller.
- Check jaw parallelism and bar straightness with a contact impression.
- Measure actual dwell at production speed.
- Inspect the seal area for product and check the air knife.
- Confirm film batch and storage condition.
- Only now consider changing settings, one at a time.
Should I just raise the sealing temperature when seals fail?
Only after you’ve ruled out pressure, dwell and contamination. Raising temperature masks other problems and costs you film and seal strength.
Why do seals pass at low speed and fail at production speed?
Almost always dwell time. Faster cycles mean less contact time. Measure dwell at real speed before changing anything.
Need Expert Assistance?
If your seals are failing and you’ve run out of settings to change, send us a photo of the failed seal and the film structure.
Post time: Nov-19-2026